| Home | E-Submission | Sitemap | Login | Contact Us |  
J. Korean Ceram. Soc. > Volume 45(1); 2008 > Article
Journal of the Korean Ceramic Society 2008;45(1): 75.
doi: https://doi.org/10.4191/kcers.2008.45.1.075
AIN-hBN계 머시너블 세라믹스의 기계적 특성 및 엔드밀링 가공성 평가
백시영, 조명우, 조원승1
인하대학교 기계공학부
1인하대학교 신소재공학부
Mechanical Properties and End-milling Characteristic of AIN-hBN Based Machinable Ceramics
Si-Young Beck, Myeong-Woo Cho, Won-Seung Cho1
Division of Mechanical Engineering, Inha University
1School of Materials Science and Engineering, Inha University
In this study, machining characteristics of AIN-hBN composites were evaluated in end-milling process. As a first step, AIN-hBN composite specimens with various hBN contents were prepared using hot press method. Material properties of the composites, such as relative density, Young's modulus and fracture toughness, were measured and compared. Then, a series of end-milling experinients were performed under various cutting conditions by changing cutting speed, depth-of-cut and feed rate. Cutting force variations were measured using a tool dynamometer during the cutting experiments. Machined surfaces of the specimens were observed using SEM and a surface pro filer to investigate the surface integrity changes. The cutting force decreased with an increases of hBN content. The cutting process was almost impossible for monolithic AIN, owing to severe chipping. In contrast, at high content of hBN, surface damage and chipping decreased, and better surface roughness can be obtained.
Key words: Machinable ceramics, Machinability evaluation, AIN-hBN, End-milling, Cutting force
Editorial Office
Meorijae Bldg., Suite # 403, 76, Bangbae-ro, Seocho-gu, Seoul 06704, Korea
TEL: +82-2-584-0185   FAX: +82-2-586-4582   E-mail: ceramic@kcers.or.kr
About |  Browse Articles |  Current Issue |  For Authors and Reviewers
Copyright © The Korean Ceramic Society.                      Developed in M2PI